DOWNLOAD Operating Instructions in PDF

CAUTION: BEFORE USING THIS TOOL READ INSTRUCTIONS THOROUGHLY. THE USE OF THIS TOOL IN ANY OTHER APPLICATION IS BOTH A VOID OF WARRANTY AND CAN LEAD TO INJURY OR EVEN DEATH.

RING MASTER (MODEL #70162) OPERATING INSTRUCTIONS: After placing bead flange as far inside the bead of tire as possible, do as follows to accomplish full installation of tire onto wheel assembly.

1. Place bottom cross bar, the bar with the two black ends as seen in Figure 1, inside of wheel at twelve and six o’clock position. Make sure the gripping plates are tight against the inner bevel of the wheel, adjust by loosening set bolts and sliding out until tight the tighten set bolts, adjust bottom gripping plate and then top, making sure as center as possible.

instructions-images-1

(Figure 1)


 2. Hang the “O” Ring on the top set bolt of the bottom cross bar so as out of the way until installation of “O” Ring (See Figure 2).

instructions-images-2

(Figure 2)


3. Slide top cross bar assembly over the threaded center rod at the nine and three o’clock positions, so that the push bars line up against the rim flange. Adjust for the tire diameter of the wheel by loosening and tightening set bolts as needed (See Figure 3).

instructions-images-3

(Figure 3)


4. Depending on amount of travel left on the threaded center rod choose a round spacer or spacers and slide onto the threaded center rod as seen in Figure4.

instructions-images-4

(Figure 4)


5. Turn the handle clockwise (See Figure 5a) onto the threaded center rod, simply turn while standing to one side until the push feet press against the rim flange, pushing the rim flange and bead of tire pass the “O” Ring groove allowing easy installation of the “O” Ring (See Figure 5b). Note: If the hand crack becomes hard to turn this usually means that the bead flange is slightly uneven with the wheel, simply tap the bead flange with a hammer and continue turning the hand crank.
instructions-images-5

(Figure 5A)

instructions-images-5b

(Figure 5B)


6. After you have installed the “O” Ring (Figure 6a) you can also install the locking-ring (Figure 6b).
instructions-images-6a

(Figure 6A)

instructions-images-6b

(Figure 6B)


7. After the locking-ring is locked into place turn the hand crack counter clockwise until off of the threaded center rod (Figure 7). Note: Hold pressure onto the top cross bar unit with one hand at the beginning until you have the hand crack threaded securely against spacer or spacers, and at the end while removing hand crank from the threaded center rod. Simply remove device from wheel and inflate the tire.

instructions-images-7

(Figure 7)

WARNING: This product as well as all tire tools should never be used by persons unless they have been properly trained according to O.S.H.A Regulation #29CFR1910.177 entitled “Servicing Single-Piece and Multi-Piece Rim Wheels.”